A novel prosthetic resin composite containing fine enamel particles
Issue title: Selected papers presented at the International Symposium on Nanotoxicity Assessment and Biomedical Environmental Application of Fine Particles and Nanotubes, Hokkaido, Japan, 16–17 June 2008, Part 2
Affiliations: Division of Biomaterials and Bioengineering, School of Dentistry, Health Sciences University of Hokkaido, Hokkaido, Japan
Note: [] Address for correspondence: Kazuhiko Endo, Division of Biomaterials and Bioengineering, School of Dentistry, Health Sciences University of Hokkaido, Ishikari-Tobetsu, Hokkaido 061-0293, Japan. Tel.: +81 133 23 1957; Fax: +81 133 23 1386; E-mail: [email protected].
Abstract: Finely powdered enamel was used to develop a prosthetic resin composite that has good mechanical properties and no potential to abrade opposing tooth structure. Bovine teeth were ground into powder and then the enamel particles were separated from the powder by centrifugation in bromoform–ethanol solution. The resin matrix consisted of UDMA (60 mole %) and Tri-EDMA (40 mole %). Camphorquinone (0.5 mass %) was added to the monomer as a photo-initiator. Fillers were incorporated directly into the resin matrix in amounts of 80 or 85 mass %. The flexural strength and Vickers hardness (Hv) were measured. The average flexural strength and Hv values for specimens having 85 mass % filler that had been subjected to heat treatment at 100°C after light-curing were 95.2 and 109.8 MPa, respectively, which are higher than those for most commercial prosthetic resin composites. These findings suggest that a novel prosthetic resin composite with good mechanical properties can be made by loading finely powdered enamel into the resin matrix.
