Affiliations: [a] College of Mechanical and Electrical Engineering, Wenzhou University, Wenzhou, China
Correspondence:
[*]
Corresponding author: Yong Li, College of Mechanical and Electrical Engineering, Wenzhou University, Wenzhou, China. Tel.: +86 13695800266; Fax: +86 0577 86689138; E-mail: [email protected]
Abstract: This letter presents a bistable permanent magnet actuator, based on double wing magnetic flux (DWMF) formed by the structure of welding sleeve and slotted armature. The double wing magnetic flux consist of high wing magnetic flux (HWMF) and low wing magnetic flux (LWMF), resulting in bistable performance under differentiating control. Parameters improvement around DWMF is analyzed based on modeling, and optimized results for a prototype actuator are obtained. The experimental and simulation results agree well, and show that the prototype actuator can realize bistable performance under the DC step voltage drive, with the holding force of 8.2 N (without current) and the restoring force of −31.7 N (with negative current), the dynamic results show that the displacement response time within 8 mm is 28 ms, of which the actuation time is 16.5 ms, the transient maximum power consumption of the restoring period is 18 W.
