Design of line-start permanent magnet motor with cost reduction and performance improvements

Issue title: Selected Papers from the 15th International Symposium on Applied Electromagnetics and Mechanics (ISEM 2011)

Article type: Research Article

Authors: Choi, Da-Woon^a | Li, Jian^a | Cho, Yun-Hyun^{a; *}

Affiliations: [a] Department of Electrical Engineering, Dong-A University, Busan, Korea

Correspondence: [*] Corresponding author: Yun-Hyun Cho, Department of Electrical Engineering, Dong-A University, 840 Hadan 2 dong, Saha-gu, Busan, 604-714, Korea. Tel.: +82 51 200 7742; Fax: +82 51 200 6944; E-mail: [email protected]

Abstract: In this paper the cost reduction design of a three-phase line start permanent magnet synchronous motor (LSPM) due to increasing price of permanent magnet recently. Cost reduction can be effectively achieved by reducing PM material through optimization of the rotor structure using the response surface method. The PM volume was decreased by about 10%, while satisfying basic performance requirements and reducing torque ripple. Prototype machines with two the rotors were built and tested. Experimental results are compared in terms of efficiency, power factor.

Keywords: Line start permanent magnet synchronous motor, response surface method

DOI: 10.3233/JAE-2012-1554

Journal: International Journal of Applied Electromagnetics and Mechanics, vol. 39, no. 1-4, pp. 873-879, 2012