Study on mechanical jointing of high temperature superconductors

Issue title: Proceedings of the tenth International Symposium on Applied Electromagnetics and Mechanics ISEM-Tokyo

Article type: Research Article

Authors: Ito, S.^{a; *} | Hashizume, H.^a | Kitajima, S.^a

Affiliations: [a] Department of Quantum Science and Energy Engineering, Tohoku University, Aramaki, Aoba, Sendai, 980-8579, Japan

Correspondence: [*] Corresponding author: S. Ito, Tel.: +81 22 217 7928; Fax: +81 22 217 7900; E-mail: [email protected]

Abstract: In the present design, the superconducting magnets can not be separated into several parts of the magnet, because of problems caused by heat generation and electromagnetic force. For the future commercial fusion reactor, however, the mountable magnets are desired to make the reactor maintenance and repair easy. In this research, therefore, a study on mechanical jointing of HTc S.C. will be performed to clarify its possibility. Two methods of the jointing are employed to compare the results. In the first method a piece of S.C. tape is put on another tape where the stress between two tapes is controlled. In the second method cross sections of two S.C. tapes are directly jointed. The voltage drop is measured to estimate the resistance in those regions and the possibility of jointing is discussed.

DOI: 10.3233/JAE-2002-397

Journal: International Journal of Applied Electromagnetics and Mechanics, vol. 14, no. 1-4, pp. 85-88, 2002