Propose of electromagnetic actuator for high efficiency EDM

Issue title: Selected papers from the International Symposium on Applied Electromagnetics and Mechanics - ISEM 2019

Guest editors: Jinhao Qiu, Ke Xiong and Hongli Ji

Article type: Research Article

Authors: Luan, Boran^a | Sun, Feng^a; | Qi, Shengfei^a | Xu, Fangchao^a | Li, Qiang^a | Zhang, Xiaoyou^{a; b} | Yang, Guang^{a; c}

Affiliations: [a] School of Mechanical Engineering, Shenyang University of Technology, Shenyang, China | [b] Department of Mechanical Engineering, Nippon Institute of Technology, Saitama, Japan | [c] School of Mechanical Engineering, Shenyang Aerospace University, Shenyang, China

Correspondence: [*] Corresponding author: Feng Sun, School of Mechanical Engineering, Shenyang University of Technology, No. 111, Shenliao West Road, Economic & Technological Development Zone, Shenyang, 110870, China. E-mail: [email protected]

Abstract: In this paper, a kind of electromagnetic actuator is developed which can solve the problem of in time controlling inter-electrode gap in traditional EDM. An incoming current in the coil of an electromagnetic actuator generates Lorentz forces that cause the electrode to move axially. When the electromagnetic actuator is working, electrode is actuated positioned quickly, and electrode is produced a displacement of plus or minus 1 mm by control. The experiment shows that the response time of the electromagnetic actuator can meet the machining requirements. The discharge probability is increased and the machining efficiency is improved.

Keywords: Electron Discharge Machining (EDM), high efficiency, electromagnetic actuate, PID control

DOI: 10.3233/JAE-209446

Journal: International Journal of Applied Electromagnetics and Mechanics, vol. 64, no. 1-4, pp. 1279-1286, 2020