3-D MHD Calculation in consideration of mold heat transfer

Issue title: Special Volume: Proceedings of the eleventh International Symposium on Applied Electromagnetics and Mechanics ISEM-Versailles ISEM 03

Article type: Research Article

Authors: Fujisaki, Keisuke^{a; *} | Nishi, Shunji^b

Affiliations: [a] Environmental & Process Technology Center, Nippon Steel Corporation, 20-1 Shintomi, Futtsu 293-8511, Japan. Tel.: +81 439 80 2460; Fax: +81 439 80 2741; E-mail: [email protected] | [b] NS Solution Corporation, 2-20-15, Shinkawa, Chuo-ku, Tokyo, 104-8280 Japan. Tel.: +81 3 5117 5888, Fax: +81 3 5117 013; E-mail: [email protected]

Correspondence: [*] Corresponding author

Abstract: A 3-D Magnetohydrodynamic calculation in consideration of mold heat transfer is developed to obtain the precise mold thermal flux and the mold design. By means of modeling the heat transfer coefficient between the solidified steel and the copper mold in casting direction distribution, the temperature distribution in the mold is in good agreement with the operating data. The mold temperature at the meniscus position is higher than the others. From the cross section temperature at the mold, the corner is higher than the center position.

DOI: 10.3233/JAE-2004-648

Journal: International Journal of Applied Electromagnetics and Mechanics, vol. 19, no. 1-4, pp. 667-671, 2004