You are viewing a javascript disabled version of the site. Please enable Javascript for this site to function properly.
Go to headerGo to navigationGo to searchGo to contentsGo to footer
In content section. Select this link to jump to navigation

Assessment of slip resistance under footwear materials, tread designs, floor contamination, and floor inclination conditions

Issue title: IEA 2012: 18th World congress on Ergonomics - Designing a sustainable future

Article type: Research Article

Authors: Li, Kai Way | Chen, Chih-Yong | Chen, Ching Chung | Liu, Liwen

Affiliations: Department of Industrial Management, Chung Hua University, Hsin-Chu, Taiwan, ROC | Institute of Occupational Safety and Health, Taipei, Taiwan, ROC | Department of Information Management, Hsing Wu College, Taipei, Taiwan, ROC

Note: [] Corresponding author. Email: [email protected]

Keywords: slips & falls, friction measurements, tread design, contamination

DOI: 10.3233/WOR-2012-0604-3349

Journal: Work, vol. 41, no. Supplement 1, pp. 3349-3351, 2012

Published: 2012
Get PDF

Abstract

Slip and fall incidences are common in our daily lives. They are not only important environmental safety issues but also important occupational safety and health problems. The purpose of this study was to use the Brungraber Mark II to measure the friction so as to investigate the effects of the shoe sole, surface condition and the inclined angle of the floor and their interactions on friction coefficient. The results of the study showed the effects of all the main factors and their interactions were significant (p<0.001). Engineering designs & ergonomic interventions in slip & fall prevention should take these factors in full consideration.

Show more