Searching for just a few words should be enough to get started. If you need to make more complex queries, use the tips below to guide you.
Issue title: Selected papers of the 4th International Symposium on Mechanobiology of Cartilage and Chondrocyte, Budapest, 20–22 May, 2006
Article type: Research Article
Authors: Ng, Kenneth W. | Mauck, Robert L.; | Statman, Lauren Y. | Lin, Evan Y. | Ateshian, Gerard A. | Hung, Clark T.;
Affiliations: Cellular Engineering Laboratory, Department of Biomedical Engineering, Columbia University, New York, NY, USA | Musculoskeletal Biomechanics Laboratory, Departments of Biomedical and Mechanical Engineering, Columbia University, New York, NY, USA
Note: [] Current address: McKay Orthopaedic Research Laboratory, Department of Orthopaedic Surgery, University of Pen-nsylvania, Philadelphia, PA, USA.
Note: [] Address for correspondence: Clark T. Hung, PhD, 351 Engineering Terrace, MC8904, 1210 Amsterdam Avenue, Department of Biomedical Engineering, Columbia University, New York, NY, 10027, USA. Tel.: +1 212 854 6542; Fax: +1 212 854 8725; E-mail: [email protected].
Abstract: The application of dynamic physiologic loading to a bilayered chondrocyte-seeded agarose construct with a 2% (wt/vol) top layer and 3% (wt/vol) bottom layer was hypothesized to (1) improve overall construct properties and (2) result in a tissue that mimics the mechanical inhomogeneity of native cartilage. Dynamic loading over the 28 day culture period was found to significantly increase bulk mechanical and biochemical properties versus free-swelling culture. The initial depth-distribution of the compressive Young's modulus (EY) reflected the intrinsic properties of the gel in each layer and a similar trend to the native tissue, with a softer 2% gel layer and a much stiffer 3% gel layer. After 28 days in culture, free-swelling conditions maintained this general trend while loaded constructs possessed a reverse profile, with significant increases in EY observed only in the 2% gel. Histological analysis revealed preferential matrix formation in the 2% agarose layer, with matrix localized more pericellularly in the 3% agarose layer. Finite element modeling revealed that, prior to significant matrix elaboration, the 2% layer experiences increased mechanical stimuli (fluid flow and compressive strain) during loading that may enhance chondrocyte stimulation and nutrient transport in that layer, consistent with experimental observations. From these results, we conclude that due to the limitations in 3% agarose, the use of this type of bilayered construct to construct depth-dependent inhomogeneity similar to the native tissue is not likely to be successful under long-term culture conditions. Our study underscores the importance of other physical properties of the scaffold that may have a greater influence on interconnected tissue formation than intrinsic scaffold stiffness.
Keywords: Cartilage, tissue engineering, inhomogeneity, digital image correlation, agarose, scaffold design
Journal: Biorheology, vol. 43, no. 3-4, pp. 497-507, 2006
IOS Press, Inc.
6751 Tepper Drive
Clifton, VA 20124
USA
Tel: +1 703 830 6300
Fax: +1 703 830 2300
[email protected]
For editorial issues, like the status of your submitted paper or proposals, write to [email protected]
IOS Press
Nieuwe Hemweg 6B
1013 BG Amsterdam
The Netherlands
Tel: +31 20 688 3355
Fax: +31 20 687 0091
[email protected]
For editorial issues, permissions, book requests, submissions and proceedings, contact the Amsterdam office [email protected]
Inspirees International (China Office)
Ciyunsi Beili 207(CapitaLand), Bld 1, 7-901
100025, Beijing
China
Free service line: 400 661 8717
Fax: +86 10 8446 7947
[email protected]
For editorial issues, like the status of your submitted paper or proposals, write to [email protected]
如果您在出版方面需要帮助或有任何建, 件至: [email protected]