Searching for just a few words should be enough to get started. If you need to make more complex queries, use the tips below to guide you.
Article type: Research Article
Authors: Lingampally, Pavan Kalyana | Doss, Arockia Selvakumar Arockiaa; * | Kadiyam, Vikram Reddyb
Affiliations: [a] Vellore Institute of Technology, Chennai, Tamil Nadu, India | [b] Viswas Hospital, Suryapet, Telangana, India
Correspondence: [*] Corresponding author: Arockia Selvakumar Arockia Doss, Vellore Institute of Technology, Chennai, Tamil Nadu, India. E-mail: [email protected].
Abstract: BACKGROUND: This article examines a dynamic wearable assistive device for individuals suffering from pain in the neck. As a part of the clinical treatment, static braces/cervical collars are suggested, however, these collars aid the person in maintaining the upright position of the head but restrict the head motion to a single configuration. To address this problem, a dynamic wearable assistive cervical collar is fabricated based on human anatomical head/neck data. OBJECTIVE: The objective of this study is to observe the strain acting on the neck surface muscles for bending and compression neck movements with and without the neck brace using a strain sensor. METHODS:To evaluate the performance of this device, experimental trials were conducted on test subjects to find out the angular tilt of the head with the device worn using the cervical range of motion (CROM) device. In addition, a neck surface muscle strain study is also conducted using strain sensors to investigate the strain produced while using the wearable assistive device. The strain on the neck surface muscle is measured using NI-9236 strain DAQ (data acquisition system). In this experimental study, a group of aged individuals with minor neck pain were recruited to study the head/neck movements. RESULTS: It was found that by using the proposed assistive device, test subjects were able to mimic 65% of human head/neck movements like flexion, extension, lateral bending, and rotation, and the strain generated from the neck surface muscle was minimal. CONCLUSION: The results show that using the designed assistive device reduced the strain on neck surface muscle, and strain obtained is within the range of 40 × 10-6 to 80 × 10-6, and may aid in recovery of the individuals suffering with neck pain.
Keywords: Neck surface muscle strain, cervical collar, parallel manipulator, dropped head syndrome, active range of motion
DOI: 10.3233/THC-220101
Journal: Technology and Health Care, vol. 30, no. 6, pp. 1503-1513, 2022
IOS Press, Inc.
6751 Tepper Drive
Clifton, VA 20124
USA
Tel: +1 703 830 6300
Fax: +1 703 830 2300
[email protected]
For editorial issues, like the status of your submitted paper or proposals, write to [email protected]
IOS Press
Nieuwe Hemweg 6B
1013 BG Amsterdam
The Netherlands
Tel: +31 20 688 3355
Fax: +31 20 687 0091
[email protected]
For editorial issues, permissions, book requests, submissions and proceedings, contact the Amsterdam office [email protected]
Inspirees International (China Office)
Ciyunsi Beili 207(CapitaLand), Bld 1, 7-901
100025, Beijing
China
Free service line: 400 661 8717
Fax: +86 10 8446 7947
[email protected]
For editorial issues, like the status of your submitted paper or proposals, write to [email protected]
如果您在出版方面需要帮助或有任何建, 件至: [email protected]