Active vibration isolation using an induced strain actuator with application to automotive seat suspensions

Article type: Research Article

Authors: Malowicki, Mark | Leo, Donald J.

Affiliations: Center for Intelligent Material Systems and Structures, Mechanical Engineering Department, Virginia Polytechnic Institute and State University, Blacksburg, VA, USA

Note: [] 307 NEB, Mechanical Engineering Department, Virginia Tech, Blacksburg, VA, 24061-0261, USA. Tel.: +1 540 231 2917; Fax: +1 540 231 2903; E-mail: [email protected]

Abstract: Active vibration isolation of automotive seats requires actuators that achieve millimeter-range displacements and forces on the order of 300 N. Recent developments in piezoceramic actuator technology provide a means for achieving these force and displacement levels in a compact device. This work demonstrates that prestressed, curved piezoceramic actuators achieve the force and displacement levels required for active isolation of automotive seats. An estimate of the force and displacement requirements are obtained from numerical simulations on a four-degree-of-freedom car and seat model that utilize representive road accelerations as inputs. An actuator that meets these specifications is designed using piezoceramic materials. Free displacement of 4.4 mm and blocked force greater than 300 N are measured. The actuator is integrated within a dead mass setup that simulates the isolation characteristics of an automotive seat. Control experiments demonstrate that active vibration is achievable with realistic road disturbances. Feedback control is able to eliminate any amplification due to mechanical resonance and reduce the isolation frequency from 9.5 Hz to 2 Hz.

Journal: Shock and Vibration, vol. 8, no. 5, pp. 271-285, 2001