Searching for just a few words should be enough to get started. If you need to make more complex queries, use the tips below to guide you.
Article type: Research Article
Authors: Zheng, Linaa | Wang, Yinib; * | Wang, Sichunb; *
Affiliations: [a] School of Economics, Guangxi University, Nanning, Guangxi, P.R. China | [b] Guangxi Key Laboratory of Seaward Economic Intelligent System Analysis and Decision, Guangxi University of Finance and Economics, Nanning, Guangxi, P.R. China
Correspondence: [*] Corresponding author. Yini Wang and Sichun Wang, Guangxi Key Laboratory of Seaward Economic Intelligent System Analysis and Decision, Guangxi University of Finance and Economics, Nanning, Guangxi, P.R. China. Yini Wang (E-mail: [email protected]); Sichun Wang (E-mail: [email protected]).
Abstract: Due to the relatively high cost of labeling data, only a fraction of the available data is typically labeled in machine learning. Some existing research handled attribute selection for partially labeled data by using the importance of an attribute subset or uncertainty measure (UM). Nevertheless, it overlooked the missing rate of labels or the choice of the UM with optimal performance. This study uses discernibility relation and the missing rate of labels to UM for partially labeled data and applies it to attribute selection. To begin with, a decision information system for partially labeled data (pl-DIS) can be used to induce two equivalent decision information systems (DISs): a DIS is constructed for labeled data (l-DIS), and separately, another DIS is constructed for unlabeled data (ul-DIS). Subsequently, a discernibility relation and the percentage of missing labels are introduced. Afterwards, four importance of attribute subset are identified by taking into account the discernibility relation and the missing rate of labels. The sum of their importance, which is determined by the label missing rates of two DISs, is calculated by weighting each of them and adding them together. These four importance may be seen as four UMs. In addition, numerical simulations and statistical analyses are carried out to showcase the effectiveness of four UMs. In the end, as its application for UM, the UM with optimal performance is used to attribute selection for partially labeled data and the corresponding algorithm is proposed. The experimental outcomes demonstrate the excellence of the proposed algorithm.
Keywords: Partially labeled data, pl-DIS, uncertainty measure, attribute selection, the missing rate of labels, discernibility relation
DOI: 10.3233/JIFS-240581
Journal: Journal of Intelligent & Fuzzy Systems, vol. Pre-press, no. Pre-press, pp. 1-18, 2024
IOS Press, Inc.
6751 Tepper Drive
Clifton, VA 20124
USA
Tel: +1 703 830 6300
Fax: +1 703 830 2300
[email protected]
For editorial issues, like the status of your submitted paper or proposals, write to [email protected]
IOS Press
Nieuwe Hemweg 6B
1013 BG Amsterdam
The Netherlands
Tel: +31 20 688 3355
Fax: +31 20 687 0091
[email protected]
For editorial issues, permissions, book requests, submissions and proceedings, contact the Amsterdam office [email protected]
Inspirees International (China Office)
Ciyunsi Beili 207(CapitaLand), Bld 1, 7-901
100025, Beijing
China
Free service line: 400 661 8717
Fax: +86 10 8446 7947
[email protected]
For editorial issues, like the status of your submitted paper or proposals, write to [email protected]
如果您在出版方面需要帮助或有任何建, 件至: [email protected]