Affiliations: Department of Mechanical Engineering, Shiraz University, Shiraz, Iran
Correspondence:
[*]
Corresponding author. Ramin Vatankhah, Department of Mechanical Engineering, Shiraz University, Shiraz 71936, Iran. E-mail: [email protected].
Abstract: This paper proposes a new method to improve fuzzy control performance accuracy in the stabilization of the two-axis gimbal system. To this end, due to the fact that the knowledge of the accurate behavior of the system plays a substantial role in fuzzy control performance, all the uncertain parameters of the dynamic model such as friction, mass imbalance and moments of inertia are estimated prior to the controller design and without imposing any computational burden on the control scheme. To estimate the uncertainties and disturbances which exist in the dynamic equations, an identification process formulated as an inverse problem is utilized, and the Gauss– Newton method is adopted for the optimization process. Regarding the severe sensitivity of inverse problems to measurement errors, this undesirable effect is reduced by using a proper smoothing technique. In order to increase the accuracy of the final results, a novel procedure for calculation of the sensitivity coefficients of the inverse problem is proposed. This procedure is based on the direct differentiation of the governing equations with respect to the unknown parameters. At the end, simulation results are presented to confirm the effectiveness of the proposed scheme.
