Optimization and comparison of two-stage thermoelectric generators considering the influence of temperature variation on materials for waste heat utilization
Affiliations: [a] College of Marine Equipment and Mechanical Engineering, Jimei University, Xiamen, Fujian, China | [b] Fujian Province Key Lab of Energy Cleaning Utilization and Development, Jimei University, Xiamen, Fujian, China | [c] Cleaning Combustion and Energy Utilization Research Center of Fujian Province, Jimei University, Xiamen, Fujian, China | [d] Marine Platform Support System Fujian University Engineering Research Center, Jimei University, Xiamen, Fujian, China | [e] Fujian Province University Key Laboratory of Ocean Renewable Energy Equipment, Jimei University, Xiamen, Fujian, China | [f] College of Marine Engineering, Jimei University, Xiamen, Fujian, China | [g] University of Bradford, West Yorkshire, Bradford, UK
Correspondence:
[*]
Corresponding authors: Wensheng Cao and Jianzhuang Xu, College of Marine Equipment and Mechanical Engineering, Jimei University, Xiamen, Fujian 361021, China. E-mail: [email protected] and [email protected].
Abstract: Thermoelectricity technology, as a kind of cost-effective and pollution-free power generation solution, is often used for waste heat recovery and utilization. In this paper, the temperature distribution of a Two-stage Thermoelectric Generator (TTEG) under constant temperature conditions has been studied using a one-dimensional heat conduction model. Moreover, by combining the obtained temperature distribution with the three-dimensional size of TTEG, a calculation formula of resistance and voltage was developed based on the calculus method. When the sum of cross-sectional areas of all the PN-type thermoelectric arms respectively in high- and low-temperature layers is constant, the optimal ratio between cross-sectional areas of a single PN-thermoelectric arm respectively in high- and low-temperature layers can be calculated using the proposed formula in this study to achieve the maximum output power. Results also showed the relationship between the heights of PN-type thermoelectric arms and the temperature distributions in high- and low-temperature layers. Using PbTe as the medium temperature thermoelectric material and Bi2Te3 as the low temperature thermoelectric material, a case study was conducted on the PN-type thermoelectrics with the same total height and the same total cross-sectional area. The theoretical calculation results showed that the bigger of maximum output power between the two-stage thermoelectric generator and that of the Segmented Thermoelectric Generator (STEG) is related to the hot and cold end temperature.
