Searching for just a few words should be enough to get started. If you need to make more complex queries, use the tips below to guide you.
Article type: Research Article
Authors: Miller, D.A. | Ahmadi, A.K.
Affiliations: SAI Consulting Engineers, Inc., 1350 Penn Avenue, Suite 300, Pittsburgh, PA 15222-4211, USA
Note: [] Corresponding author. Email: [email protected]
Abstract: The Interstate 79 Neville Island Interchange Bridge complex located north of Pittsburgh, Pennsylvania, carries four through lanes of the Interstate over Neville Island and the main and back channels of the Ohio River. The mainline bridge consists of a tied through arch span and 26 dual parallel approach spans. These mainline dual approach spans are continuous units comprised two welded steel plate deck girders, welded steel plate floorbeams and rolled steel wide-flange stringers. In addition, the complex includes eight ramp bridges consisting of both straight and curved continuous dual welded steel plate girders, welded steel plate or rolled wide-flange floorbeams and rolled steel wide-flange stringers. These structures, built and opened to traffic during the early to mid-1970s, are owned and maintained by District 11-0 of the Pennsylvania Department of Transportation. All nine bridges are considered fracture-critical (FCM) owing to the two-girder floorbeam system used on the mainline approach spans and all of the ramp bridges. The steel welded box tie-girder of the main tied-arch span also makes this span fracture-critical. SAI Consulting Engineers, Inc. has performed the required annual NBIS and FCM inspections for the last15 years on most of these structures. There were many brittle fracture and fatigue-prone details that were of concern; some of which were cracked. These details included girder-floorbeam and stringer-diaphragm out-of-plane distortion, floorbeam flange end terminations, floorbeam-to-girder welded kneebrace connections, poor weld details at back-up bar splices, intersecting welds of transverse and longitudinal stiffeners, etc. In 2000 and 2005, SAI developed fatigue retrofits for nine brittle fracture or fatigue sensitive-type details that were part of two major design rehabilitation contracts. In 2003, SAI also designed retrofit-type repairs for an emergency contract to retrofit existing Hoan-like details. This paper discusses the design, fabrication, and construction of the retrofits for these various brittle fracture and fatigue-prone details.
Keywords: Bridges, Steel, Fatigue, Fracture
DOI: 10.1080/15732480601103648
Journal: Bridge Structures, vol. 3, no. 1, pp. 35-50, 2007
IOS Press, Inc.
6751 Tepper Drive
Clifton, VA 20124
USA
Tel: +1 703 830 6300
Fax: +1 703 830 2300
[email protected]
For editorial issues, like the status of your submitted paper or proposals, write to [email protected]
IOS Press
Nieuwe Hemweg 6B
1013 BG Amsterdam
The Netherlands
Tel: +31 20 688 3355
Fax: +31 20 687 0091
[email protected]
For editorial issues, permissions, book requests, submissions and proceedings, contact the Amsterdam office [email protected]
Inspirees International (China Office)
Ciyunsi Beili 207(CapitaLand), Bld 1, 7-901
100025, Beijing
China
Free service line: 400 661 8717
Fax: +86 10 8446 7947
[email protected]
For editorial issues, like the status of your submitted paper or proposals, write to [email protected]
如果您在出版方面需要帮助或有任何建, 件至: [email protected]