GA based energy loss minimization approach for optimal sizing & placement of distributed generation

Article type: Research Article

Authors: Singh, Deependra^{a; *} | Singh, Devender^b | Verma, K.S.^a

Affiliations: [a] Electrical Engineering Department, Kamla Nehru Institute of Technology, Sultanpur (UP), India | [b] Electrical Engineering Department, Institute of Technology, BHU, Varanasi (UP), India

Correspondence: [*] Corresponding author. Deependra Singh, Tel.: +91 941 5156 186; Fax: +91 536 2240 454; E-mail: [email protected]

Abstract: Distributed Generators (DG) provide the lowest cost solution to handle low voltage or overload problems. In conjunction with such problems, a technique of energy saving is introduced by placement of distributed generation (DG) in distribution systems. A GA based optimal sizing and placement of DG keeping in view of system energy loss minimization in different loading conditions with time varying loads is explained. Minimal annual system energy loss is calculated under voltage and line loading constraints. Proposed strategy is applied to power distribution systems and its effectiveness is verified through simulation results on 16-bus, 37-bus and 75-bus systems with time varying load.

Keywords: Distributed generation (DG), genetic algorithms (GA), optimal sizing and placement, energy saving

DOI: 10.3233/KES-2008-12206

Journal: International Journal of Knowledge-based and Intelligent Engineering Systems, vol. 12, no. 2, pp. 147-156, 2008