Searching for just a few words should be enough to get started. If you need to make more complex queries, use the tips below to guide you.
Article type: Research Article
Authors: Milstein, Adama | Wang, Taob
Affiliations: [a] Department of Computer Science, University of Waterloo, Waterloo, Ontario, Canada; 221 Athabasca Hall, University of Alberta, Edmonton, Alberta, T6G 2E8, Canada. Tel.: +1 780 492 3726; E-mail: [email protected] | [b] Department of Computing Science, University of Alberta, Edmonton, Alberta, Canada. E-mail: [email protected]
Abstract: Localization is the problem of determining a robot's location in an environment. Monte Carlo Localization (MCL) is a method of solving this problem by using a partially observable Markov decision process to find the robot's state based on its sensor readings, given a static map of the environment. MCL requires a model of each sensor in order to work properly. One of the most important sensors involved is the estimation of the robot's motion, based on its encoders that report what motion the robot has performed. Since these encoders are inaccurate, MCL involves using other sensors to correct the robot's location. Usually, a motion model is created that predicts the robot's actual motion, given a reported motion. The parameters of this model must be determined manually using exhaustive tests, but a single model cannot optimally represent a robot's motion in all cases. Thus, it is necessary to have a generalized model with enough error to compensate for all possible situations. However, if the localization algorithm is working properly, the result is a series of predicted motions, together with the corrections determined by the algorithm that alter the motions to the correct location. We demonstrate a technique to process these motions and corrections and dynamically determine revised motion parameters that more accurately reflect the robot's motion. We also link these parameters to different locations so that area dependent conditions, such as surface changes, can be taken into account. Finally, the dynamic technique allows various different motion models to be used with minimal work. By using the fact that MCL is working, we have improved the algorithm to adapt to changing conditions so as to handle even more complex situations.
DOI: 10.3233/ICA-2007-14304
Journal: Integrated Computer-Aided Engineering, vol. 14, no. 3, pp. 243-262, 2007
IOS Press, Inc.
6751 Tepper Drive
Clifton, VA 20124
USA
Tel: +1 703 830 6300
Fax: +1 703 830 2300
[email protected]
For editorial issues, like the status of your submitted paper or proposals, write to [email protected]
IOS Press
Nieuwe Hemweg 6B
1013 BG Amsterdam
The Netherlands
Tel: +31 20 688 3355
Fax: +31 20 687 0091
[email protected]
For editorial issues, permissions, book requests, submissions and proceedings, contact the Amsterdam office [email protected]
Inspirees International (China Office)
Ciyunsi Beili 207(CapitaLand), Bld 1, 7-901
100025, Beijing
China
Free service line: 400 661 8717
Fax: +86 10 8446 7947
[email protected]
For editorial issues, like the status of your submitted paper or proposals, write to [email protected]
如果您在出版方面需要帮助或有任何建, 件至: [email protected]